Configuration Of The System - Siemens XC1003-A Operation

System overview
3.1

Configuration of the system

10
Building Technologies
Fire Safety & Security Products
Every extinguishing system is individually configured. The configuration has an
effect on operation. The following table shows the configuration of your automatic
extinguishing system.
Function
Activation of access level 2
Setting of activated time
Setting of flooding time
Sound mode of alarm horn
Fixed running time of alarm horn
Reminder beep every 4 minutes upon "Fault"
and "Part of system off"
Emergency hold button installed
Emergency abort button installed
Other blocking devices
Extinguishing agent monitoring
Pressure switch for state "Released"
Trigger condition for automatic activation of
extinguishing
Alarm verification activated
Direct remote transmission
Transmission to the fire detection control unit
Maximum operating time in the event of mains
power failure
Fault delay in the event of power failure
System reset not possible as long as alarm
horn or manual release button or pressure
switch (released) is active
Faults must be reset after being eliminated
Configuration
[ ] using standard access code
[ ] using individual access code
........ seconds
........ seconds
State "Fire alarm" [ ] slow pulsating
[ ] continuous
[ ] not activated
State "Activated" [ ] continuous
[ ] pulsating
State "Released" [ ] pulsating
[ ] continuous
[ ] yes ........minutes
[ ] no
[ ] activated
[ ] not activated
[ ] yes
[ ] no
[ ] yes
[ ] no
.....................................................................
[ ] yes
[ ] no
[ ] yes
[ ] no
[ ] Detector zone 1 or 2
[ ] Detector zone 1 and 2
[ ] Detector zone 1 and 2 and 3
[ ] yes
[ ] no
[ ] yes [ ] fire alarm
[ ] no [ ] activated
[ ] extinguishing activated
[ ] fault
[ ] yes [ ] fire alarm
[ ] no [ ] activated
[ ] extinguishing activated
[ ] fault
[ ] blocked
........ hours
........ minutes
[ ] yes
[ ] no
[ ] yes
[ ] no
A6V10099835_a_en
12.2007