Infinite TRANSTECTOR 700 AV/T Series Owner's Manual page 34

Quadruple Output Power Conditioner | Owners Manual
34
3.10 OPERATING FREQUENCY
60 Hertz ±3 Hertz
3.11 HARMONIC DISTORTION
Less than 1 % THD added to the output waveform under any dynamic linear loading conditions
presented to the line regulator.
3.12 TURN-ON CHARACTERISTICS
When energized the voltage overshoot is 5 % or less of the nominal voltage for less than 1 cycle.
3.13 OVERLOAD RATING
200 % for ten minutes.
1000 % for one cycle.
3.14 NOISE ATTENUATION
Common mode noise attenuation is typically 140 dB or greater.
Transverse mode noise attenuation is 3 dB down at 1000 Hertz, 40 dB down per decade to below 50
dB with a resistive load.
3.15 AUDIBLE NOISE
Not to exceed 55 dB measured @1 meter
3.16 EFFICIENCY
98 % Typical at full load. Excitation losses shall be less than 0.75 % of KVA rating
3.17 BTU
The Power Line conditioner shall generate no more than 3,090 BTU/Hour @ full load.
3.18 POWER FACTOR
Input power factor shall be greater than .95 with a resistive load and reflect no triplen harmonics to
the utility under non-linear loads.
3.19 LINE to LINE BALANCE
The Power Line Conditioner shall not produce more than a 2 % phase to phase unbalance
3.20 MTBF
The system shall exhibit a MTBF > 10,000 hours.
3.21 SURGE and SPIKE SUPPRESSION
A Transtector model SPD SP 60 TVSS shall be installed parallel to the secondary output of the power
line conditioner to provide all-mode, bi-directional and bi-polar surge protection. The SPD is rated for
120 kA per phase, 60 kA per mode capacity. (L-L, L-N, L-G, N-G) The suppression network system
shall conform to UL 1449 ratings when subjected to ANSI/IEEE C62.41-1991 category C3 waveforms.
Unit shall be UL 1283 listed as an electromagnetic interference filter. Units shall provide attenuation
against EMI/RFI noise up to 50 dB at 1 MHz. The surge suppressor is installed on the load side of the
transformer, connected in parallel by a 30 Amp circuit breaker.
|
/v