Bypass Switch - Infinite TRANSTECTOR 700 AV/T Series Owner's Manual

STORING
If it is necessary to store the unit for a period of time before it is installed, be sure to place the unit in a clean, dry
area. To prevent excessive dust from accumulating on the unit, it is advisable to protect it by replacing it in the
Quadruple Output Power Conditioner | Owners Manual
original container (if possible). If the original container is not available it is recommended that all openings that
lead internally into the unit are covered so that dust, water or any other substance cannot enter the internal
components of the system. The unit must be handled at all times with the same care you would give to any piece

BYPASS SWITCH

of precision industrial equipment.
The manual bypass switch is a break before make switch located on the Series 700AV/T. The manual REMOVING THE POWER PROCESSOR FROM PALLET
The manual bypass switch is a break before make switch located on the Series 700AV/T. The manual bypass
bypass switch is used to by-pass all power electronics in case of failure.
switch is used to by-pass all power electronics in case of failure.
Please take special care when removing the unit from the pallet. Depending on the size and weight of the unit,
NORMAL MODE
proper equipment must be used for lifting and moving, and all safety precautions should be taken. Each unit is
NORMAL MODE
bolted to a wooden pallet. In order to properly remove the cabinet from the pallet, all bolts connecting the unit to the
With the switch in the normal position, the Series 700AV/T will provide clean and regulated power to
pallet must be removed completely. Most sizes must be lifted off with a pallet jack or a fork lift.
the critical loads. The Series 700AV/T should have the switch in the normal position unless a failure
With the switch in the normal position, the Series 700AV/T will provide clean and regulated power to the critical
unit off of the pallet, be sure to take proper safety precautions. Serious injury and/or unit damage can result
has occurred.
loads. The Series 700AV/T should have the switch in the normal position unless a failure has occurred.
otherwise.
BYPASS MODE
BYPASS MODE
With the switch in the bypass position, the Series 700AV/T will provide clean power to the critical
With the switch in the bypass position, the Series 700AV/T will provide clean power to the critical loads. In the
loads. In the bypass position, the unit will not regulate the incoming voltage. The Series 700AV/T
bypass position, the unit will not regulate the incoming voltage. The Series 700AV/T should be placed in the
should be placed in the bypass position when a failure of the system has occurred. This provides the
bypass position when a failure of the system has occurred. This provides the user with some protection until a
user with some protection until a service technician arrives.
service technician arrives.
Prior to switching from one position to another- turn off the AC input breaker.
REMOTE EMERGENCY POWER OFF (REPO) OPTION
REMOTE EMERGENCY POWER OFF (REPO) OPTION
The REPO is operated by a remote push button that when depressed will shunt trip the Series 700AV/T input
The REPO is operated by a remote push button that when depressed will shunt trip the Series 700AV/T
breaker and disable the unit. This option may be added to units in the field.
input breaker and disable the unit. This option may be added to units in the field.
Contact the Customer Support Department if you wish to add this option.
Contact the Customer Support Department if you wish to add this option.
|
/v
BYPASS SWITCH
***CAUTION***
PAGE 6
PAGE 23
16
When lifting the