Kwikset SMARTCODE 914 Installation And User Manual page 3

6 Pair the lock with your smart home system
A
Initiate the pairing process at your smart
home controller. Refer to your smart home
system instructions for more information.
Note: See supplied flyer for provider websites
and contact information as applicable.
7
Add user codes
It is recommended that you add and
delete all user codes through your smart
home control system. If your system
does not allow this, codes may be added
directly to the lock as shown here.
Mastercode
For enhanced security, a mastercode may
be used when adding and deleting user
codes. For more information about the
mastercode, download the SmartCode
914 Programming and Troubleshooting
Guide at www.kwikset.com.
Programming Timeout
During programming, if no button is
pressed for five seconds, the system will
time out (indicated by three beeps and a
red flashing keypad), and you will need to
restart the procedure.
Test the lock (review normal operation)
8
Confirm that the code(s) added in step 7 can unlock the door.
Locking the Door
Press Lock button once.
9
Re-key the lock (if needed) and install the battery cover
A
Re-key the lock (if needed).
a
J
IMPORTANT:
Remove battery
pack before
re-keying.
B
When prompted by your smart home
system to initiate pairing at the lock, press
button "A" on the lock interior four times.
A
Make sure the door is open. Press
the Program button once.
D
Did the keypad flash green once with one beep or flash red three times with three beeps*?
One green flash with one beep
green
Programming was successful.
Proceed to step 8.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon.
c
b
Re-key the lock Reinstall
to work with your battery
existing key. See pack.
the supplied
SmartKey Re-key
instructions for
more information.
S
C
If the pairing process is successful, re-name
the lock in your system (if applicable).
D
If the pairing process is unsuccessful, press button
"B" nine times.
Perform steps 6A-6C again.
If pairing is still unsuccessful, consult the SmartCode
914 Programming and Troubleshooting Guide online
at www.kwikset.com.
B
Enter user code. A total of 30 user
codes may be programmed.
Each user code
must be a unique
code between
4 and 8 digits,
depending on
home system.
or
1x
Unlocking the Door
Enter user code.
B
Install the battery cover.
a
J
L
C
Press Lock button once.
your smart
Three red flashes with three beeps
red
3x
Programming was unsuccessful.
Make sure the user code is not a duplicate and that it is between
4 and 8 digits during your next attempt.
Make sure the lock has room for an additional code. If all user code
positions are filled, delete a code to make room for this one.
b
G
ball tip
Keep "G" in a safe place, as you will need it to access
the back panel for additional programming.
R (3x)