Appearance Of Expansion Unit/Module - FATEK FBs Series User Manual

○
8
Indicators for transmit (TX) and receive (RX) status of built-in communication port (Port0).
○
9
Indicator for Digital Input (Xn).
○
10
Indicator for Digital Output (Yn).
○
11
Indicator for system status (POW, RUN, ERR).
○
12
I/O output expansion header cover [units of 20 points or beyond only], with esthetic purpose and capable of securing
expansion cable.
○
13
FB -CB22 Communication Board (CB).
S
○
14
FB -CB22 CB cover plate (each CB has its own specific cover plate)
S
○
15
Screw holes of communication board.
○
16
Connector for communication board (for 7 types CB of CB2, CB22, CB5, CB55, CB25, CBE, CBCAN , 3 types AIO
of B2DA, B2AD, B4AD, and 2 types DAP of BDAP and BPEP)
○
17
Left side (communication) expansion header (only available in MC/MN model, for CM22, CM25, CM55, CM25E,
CM55E, and CMGSM connection).
○
18
Connector for Memory Pack.
○
19
Connector for built-in communication port (Port 0) (With USB and RS232 optional, shown in the figure is for RS232)
○
20
Right side (I/O) output expansion header (only available in units with 20 points or beyond), for connecting with
cables from expansion units/modules.
1.2

Appearance of Expansion Unit/Module

There are three types of cases for expansion units/modules. One type uses the same case as main unit that of the 90mm,
130mm, and 175mm, while the other two have thinner 40mm and 60mm cases, which are for expansion modules. All
expansion cables (left) of expansion units/modules are flat ribbon cables (5cm long), which were soldered directly on the PCB,
and the expansion header (right) is a 14Pin Header, with this to connect the right adjacent expansion units/modules. In the
following, each of the three types of expansion units/modules is described as an example:
Expansion unit/module with 90mm, 130mm, or 175mm width case: [ -24XY
Screw hole
4.5 2
ψ ×
Expansion cable
connector
Digital output terminal block and
Main power input (for XY-
Digital input
terminal block
24V IN X1 X3 X5 X7
S/S X2 X4 X6
I 2
5 6 7
9 I0
I3 I4
PROGRAMMABLE
CONTROLLER
POW
I 2
5 6
I0
9
Y2 Y3 Y5 Y6
C1 Y1 C3 Y4 C5
DIN RAIL tab
)
-16RTD]
Input status
Output expansion slot
indicator
cover plate
X9 X11 X13
X8 X10 X12 X14
3 4
8
I I I2
IN X ( )
OUT Y ( )
3 4
7 8
FBs-24XYR
Y7 Y9
C7 Y8 Y10
Output status indicator
H1-2
-40XY , -60XY
◇–◎, ◇–◎
Front view of output expansion slot with
cover plate removed
Output expansion slot
, -16TC,
◇–◎