GILES FSH-2 Operation & Service Manual page 33

Overview
3.02 Control Box w/Timer
Item
E.A.C. Filter Status
1
HOOD POWER
2
FRYER POWER
3
4 FILTER MISSING
5
PUSH-TO-START
* 6
CHANGE SOON
* 7
CHANGE NOW
* 8
*
Not present on HEPA Filter Models
Description
LED light cluster indicates status of the Electronic Air Cleaner (E.A.C.)
system.
[ON] - Turns ON when hood is powered-up. Indicates that the E.A.C.
system is powered and functioning normally to clean the air. This is the
only light ON when operating normally.
[WASH] - Indicates excessive grease film build-up on collector fins
Indicators
(dirty), collector cell is missing, poor connection, missing ionizer wires,
etc. Approximately 2 minutes after this light turns ON, an intermittent
[ON]
(beeping) alarm tone sounds and power to fryer is shutdown.
[WASH]
IMPORTANT! Do not rely on this indicator as a signal for routine
[CHECK]
cleaning; cell must be cleaned daily to maintain peak performance and
extend useful life of charcoal filters.
[CHECK] - Indicates that collector cell has stopped operating properly; is
damaged
moisture, etc. No alarm sounds
electronic air cleaning is not functioning. Discontinue operation &
inspect.
Indicates that hood is powered and running.
Indicates that power is being supplied to the fryer under the hood.
Indicates that baffle and/or charcoal filter is missing or improperly
installed.
Turns hood power ON and OFF. When hood fan is running sufficiently
to provide capture, power is supplied to the fryer. To start hood, press
Power Switch
and momentarily hold the top START portion of the switch; release
when fan starts and switch springs back to remain ON. Hood must be
restarted in this manner after any lost of power.
Illuminates when the EAC Cleaning Timer enters [WARNING] mode.
The cell needs to be cleaned (or exchanged with a clean standby)
within the next 24 hours.
Illuminates when the EAC Cleaning Timer enters [TIMEOUT] mode.
Allowed time between cleanings (or exchange) has expired. The cell
must immediately be cleaned (or exchanged). An audible alarm
sounds and both hood and fryer are locked out, preventing continued
operation until the appropriate activities are performed.
Pressing this button delays [TIMEOUT] mode for 2 hours, thus allowing
the hood and fryer to continue operating to finish a cook cycle or meet
SNOOZE
customer demand. Two (2) snooze cycles are allowed, then shutdown
proceeds.
Model: FSH-2, FSH-2A-99
Function
shorted to ground, fins are shorted due to excessive
&
the fryer remains powered, but
&
23