Table of Contents
Advertisement
This chapter is designed to help the user identify and rectify basic faults or the
results of incorrect operation. When locating a fault, proceed in the order shown in
the table.
Fault
• Key switch in "0" position
• Battery charge too low
tugger
does not
• Faulty fuse
start.
• tugger in charge mode
• Excessive load
If the fault cannot be rectified after carrying out the remedial procedure, notify the
manufacturer's service department as any further troubleshooting can only be
performed by specially trained and qualified service personnel.
SECTION 6 TROUBLESHOOTING
Possible cause
• Set key switch to "I"
• Check battery charge, charge
battery if necessary
• Test fuses
• Interrupt charging
• Note maximum capacity (see
towing capacity decal)
24
Action
Hide quick links:
Advertisement
Table of Contents
