Fiat Linea Owner's Handbook Manual page 152

fig. 5
❒ for versions with wheel caps, remove the
cap after unscrewing the three fastening
bolts and finally unscrew the fourth bolt
L-fig. 5 and remove the wheel;
❒ make sure the contact surfaces between
spare wheel and hub are clean so that
the fastening bolts will not come loose;
❒ fit the spare wheel by inserting the first
bolt two threads into the hole closest
to the inflation valve;
F0R0156m
fig. 6
❒ fit the wheel cap by aligning the cres-
cent hole with the bolt you have fitted
using the wrench;
❒ tighten the fastening bolts;
❒ turn the jack handle L-fig. 4 to lower
the car and remove the jack;
❒ use the wrench provided to fasten the
bolts completely, passing from one bolt
to the opposite one, in the order shown
in fig. 6;
❒ if you are replacing an alloy wheel and
wish to store it temporarily in the spare
wheel compartment, you should posi-
tion it upside down with the display sur-
face upwards.
REFITTING THE
STANDARD WHEEL
Following the procedure described previ-
ously, raise the car and remove the spare
wheel.
F0R0157m
151