Environmental conditions
The IT8900 series electronic load can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
Environmental conditions
Operating temperature
Operating humidity
Storage temperature
Altitude
Installation category
Pollution degree
Regulation tag
Never touch cables or connections immediately after turning off the
instrument. Verify that there is no dangerous voltage on the electrodes or
sense terminals before touching them.
If the equipment is not used in the manner specified by the manufacturer,
its protection may be damaged.
Always use dry cloth to clean the equipment housing. Do not clean the
inside of the instrument.
Do not block the air vent of the equipment.
Note
In order to ensure the accuracy of measurement, it is recommended to operate the
instrument half an hour after start-up.
Copyright © ITECH Electronic Co., Ltd.
Requirement
0°C - 40°C
20% - 80% (non condensing)
-20°C - 70 °C
Operating up to 2,000 meters
Ⅱ
Pollution degree 2
The CE tag shows that the product complies with
the provisions of all relevant European laws (if the
year is shown, it indicates that the year when the
design is approved).
This instrument complies with the WEEE directive
(2002/96/EC) tag requirements. This attached
product tag shows that the electrical/electronic
product cannot be discarded in household waste.
This symbol indicates that no danger will
happen or toxic substances will not leak or
cause damage in normal use within the
specified period. The service life of the product
is 10 years. The product can be used safely
within the environmental protection period;
otherwise, the product should be put into the
recycling system.
IT8900 User Manual
iii
Need help?
Do you have a question about the IT8900 Series and is the answer not in the manual?