Engine Cover - Porsche 911 GT3 Cup MR Gen. II Technical Manual

5.10 Engine Cover

► The weight-optimized engine cover is made of carbon fiber composite. The standard hinges are also
replaced by weight-optimized retaining pins.
► The engine cover is inserted onto the two tabs on the wing supports and then fixed to the front hol-
ding peg using two lock pins.
As part of vehicle preparation, both the tabs on the wing supports and
ATTENTION
the mounts and studs on the body must be checked for firm seating
and damage.
Care must be taken that the two pins in the wing supports engage in
NOTE
the recesses in the engine cover. If this is not observed, the cover can-
not be attached properly.
Damaged lock pins must be replaced immediately.
NOTE
Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
BODY EXTERIOR | Engine cover
58
Home