Troubleshooting - AEG Protect D Series User Manual

Hide thumbs Also See for Protect D Series:
Table of Contents

Advertisement

62

8. TROUBLESHOOTING

To check the Event log:
1.
By pressing
2.
Scroll through the listed events or faults.
3.
The following table describes typical conditions.
Conditions
Battery mode
Battery (Orange) LED
is On.
1 beep every 4
seconds.
Code: 168
Battery low
Battery (Orange) LED
is On.
1 beep every 1
second.
Code: 56
No battery
Fault (Red) LED is
Flash
1beep every 1 second
Code: 199
on the menu of "Event log".
Possible cause
A utility failure has
occurred, and the
UPS is in Battery
mode.
The UPS is in Battery
mode and the battery
is running low.
The batteries are
disconnected.
Action
The UPS is powering
the equipment with
battery power.
Prepare your
equipment for
shutdown.
This warning is
approximate, and the
actual time to
shutdown may vary
significantly.
Depending on the
UPS load and number
of Extended Battery
Modules (EXTERNAL
BATTERY MODULE s),
the "Battery Low"
warning may occur
before the batteries
reach 20% capacity.
Verify that all
batteries are properly
connected.
If the condition
persists, contact your
service
representative.

Advertisement

Table of Contents
loading

Table of Contents