Canon Arizona 1300 Series User Manual page 46

Print Job Control Module
[19] Command Toolbar
Command Toolbar Icons Explained
Print job
Hold job
Cancel job
Delete job
Flatbed Enable
Flatbed Settings
46 Chapter 4 - Navigate the User Interface
This command can do the following actions depending on context:
• Activates a selected inactive job by moving it to the active list.
• Un-holds a held job.
• Un-holds a job that had an error currently.
The command can do following actions depending on context:
• Puts an active job on hold.
• Waits until the printer finishes a currently printing copy and puts the job
on hold.
The command can do following actions depending on context:
• Deactivates a selected active job by moving it to the inactive list. Note
that Special Prints will not move to the inactive list.
• Cancels a currently printing job and moves it to the inactive list. Note
that the first click cancels the print, but the carriage will continue to ap-
ply curing passes so that the ink cures properly. A second click termi-
nates the print job immediately.
Deletes a job from the printer. However, you cannot delete a job that is cur-
rently printing.
Enables or disables the flatbed print queue. This must be selected to ena-
ble flatbed printing when the printer is booted or after re-setting the printer
due to an error.
A dialogue window automatically appears when confirmation is required. If
it is closed before you select Confirm, it can be reopened by clicking on this
button.
Media Parameters
Enter or confirm the thickness of the media. The printer will automatically
adjust the carriage height to create the proper print gap for the specified
media thickness. Media thickness confirmation is required only for the first
copy of a print job, unless it is changed during printing. If the media thick-
ness value is changed while printing, confirmation is requested before
printing the next copy.
UV LED Power Control
Allows the operator to control the power output of each UV LED unit inde-
pendently. To extend lamp life, use the lowest setting that provides ade-
quate curing for a particular media.
Leading and Trailing Edge are relative to the direction of carriage travel. To
enable or disable this setting, see the User Interface section of the Settings
page "Tie lamp controls together". When enabled, this feature automatical-
ly matches the power of the trailing UV LED unit, when power of the lead-
ing UV LED unit changes. It is still possible to adjust the power of the trail-
ing UV LED unit individually, when this setting is not enabled.
4