7.
Remove the speakers from the computer (3) .
Reverse this procedure to install the speakers.
Fingerprint sensor board
To remove the fingerprint sensor board, use this procedure and illustration.
Table 5-6
Fingerprint sensor board description and part number
Description
Fingerprint sensor board
Fingerprint sensor bracket (available in the Bracket Kit)
Before removing the fingerprint sensor board, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover
3.
Remove the battery (see
4.
Remove the speaker (see
Remove the fingerprint sensor board:
1.
Remove the two Phillips M2.0 × 2.0 screws (1) that secure the fingerprint sensor bracket, and then
remove the bracket (2).
2.
Disconnect the cable from the ZIF connector on the system board (3).
28
Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page
22).
Battery on page
23).
Speakers on page
26).
Spare part number
M10726-001
M16097-001
22).