Solid-State Drive; Touchpad; Solid-State Drive Cover (Included In The Miscellaneous Kit) M10735-001; Solid-State Drive (2230, Pcie, Nvme) - HP Elite C1030 Chromebook Maintenance And Service Manual

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-3 Solid-state drive descriptions and part numbers
Description
256 GB, PCIe, value
128 GB, PCIe, value
Solid-state drive cover (included in the Miscellaneous Kit)
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Use a thin tool to remove the cover from the solid-state drive (1).
2. Remove the Phillips M2.0 × 3.0 screw (2) that secures the drive to the computer.
3. Pull the drive away from the socket to remove it (3).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Replace the cover by inserting the edges of the cover into the clips on the system board near the sides of the
solid-state drive.

Touchpad

To remove the touchpad, use this procedure and illustration.
(Preparation for disassembly on page
(Bottom cover on page 22).
22).
Battery on page 23).
Component replacement procedures
Spare part number
M11042-002
M11040-002
M10735-001
25