Amphenol 957-7610 Assembly Procedure

Rj sealed connectors

Assembly Procedure for RJ Sealed Connectors

Procedure to be used for terminating and assembling of Amphenol Connector Kit Part Number 957-7610

Step 1: Feed CAT cable through boot and connector housing as shown below.

Note: Care should be taken not to damage the rubber sealing gasket inside the rear of the

A) Strip jacketing and shield as shown

B) Fold shield back onto jacketing.

Wrap drain wire one and a half times

around the shield.

Trim excess length from drain wire

Amphenol Fiber Optic Products – 2100 Western Court, Suite 300 – Lisle, IL 60532 – P (800) 944-6446 – F (630) 810-5880 www.amphenol-fiberoptics.com

Page 1 of 2

connector housing.

C) Untwist pairs and arrange to desired order.

Note: It is recommended to follow TIA-

568 specifications for wiring orientation

Trim conductors at an angle and insert into

the loading bar

D) Trim excess wire from holder

Insert prepared cable into RJ-45 Plug

949-1690 Rev. B

Table of Contents

Do you have a question about the 957-7610 and is the answer not in the manual?

Page 1 Insert prepared cable into RJ-45 Plug Trim excess length from drain wire Amphenol Fiber Optic Products – 2100 Western Court, Suite 300 – Lisle, IL 60532 – P (800) 944-6446 – F (630) 810-5880 www.amphenol-fiberoptics.com Page 1 of 2 949-1690 Rev. B...
Page 2 Recommended tightening torque is 5.5 to 6.0 (in-lbs) or 0.62 to 0.68 (N-m) Amphenol Fiber Optic Products – 2100 Western Court, Suite 300 – Lisle, IL 60532 – P (800) 944-6446 – F (630) 810-5880 www.amphenol-fiberoptics.com Page 2 of 2...
Page 3 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Amphenol 957-7610...