Bosch MUZ9VL1 Instruction Manual page 6

en Preparation
Preparation
W Risk of injury
– Do not grasp the sharp blades or edges
of the cutting discs. Only grip the cutting
discs by the plastic or the edge!
– Before attaching or removing the
accessory, wait until the drive has come
to a standstill and pull out the mains plug.
– The accessory must be completely
assembled before use.
– Never assemble the accessory on the
base unit.
– The accessory should only be used in
the intended operating position.
X Image sequence B
Important: Only prepare the base unit as
described in the main operating instructions.
The continuous-feed shredder can only
be operated if the bowl is fitted properly
(without lid).
1. Insert the disc holder in the housing.
Both wings must be at the bottom.
2. Place the required cutting disc on the
disc holder. Check which side is facing
upwards.
3. Fit the lid (,).
4. Rotate the lid in a clockwise direction as
far as possible (;).
6
Use
W Risk of injury
Never reach into the feed chute. Only use
the pusher provided when adding food.
Caution!
– Prevent the cut ingredients from building
up in the outlet opening.
– Do not apply great force with the pusher.
X Image sequence C
1. Position the continuous-feed shredder
as shown on the front yellow drive.
2. Press down and rotate in a clockwise
direction as far as possible.
3. Plug the mains plug into the mains.
Turn the rotary switch to the
recommended speed.
4. Add the prepared food to the feed chute.
5. Only use the pusher provided to add
food.
6. When you have finished processing or
when the processed food in the bowl
almost reaches the outlet opening,
turn the rotary switch to y. Wait
until the drive comes to a standstill.
Disconnect the mains plug.
7. Press the release button and raise
the swivel arm with the continuous-feed
shredder to the stop.
8. Rotate the bowl clockwise, empty and
remove it.
9. Press the release button and push the
swivel arm down to the stop.
10. Rotate the continuous-feed shredder
anticlockwise and remove.
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 7
Note: To ensure uniform cutting results,
process thin ingredients in bunches.