Assa Abloy Yale Locks YRL216 Integrator Manual page 7

Installing the Z -Wave
IMPORTANT: the batteries
to removing and/or inserting the network module:
• Remove battery cover and batteries.
• Remove and/or insert Network Module.
• Reinstall batteries and battery cover.
Adding / Removing the Network Module:
This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave
Plus messages to communicate to other security enabled Z-Wave Plus products. This device
must be used in conjunction with a Security Enabled Z-Wave Controller in order to fully utilize
all implemented functions. This product can be operated in any Z-Wave network with other
Z-Wave certified devices from other manufacturers. All non-battery operated nodes within
the network will act as repeaters regardless of vendor to increase reliability of the network.
To Add the Module (Inclusion Mode):
• Enter the 4-8 digit Master PIN code followed by the
• Press the key followed by the
• Press the key followed by the
To Remove the Module (Exclusion Mode):
• Enter the 4-8 digit Master PIN code followed by the
• Press the key followed by the
• Press the key followed by the
Factory Reset - If No Controller:
• See the Lock Installation Manual
• Please use this procedure only when the network primary controller is missing or
otherwise inoperable.
For specific Z-Wave Plus association and parameter information for your lock, please visit
YaleResidential.com/ZwavePlus
Yale Real Living Z
®
Installation and Programming Instructions
®
Plus Module
must be removed prior
key.
key.
key.
key.
® ®
-Wave Plus Module
key.
key.
P/N AYR202-ZW-INSTAL-FUL Rev B