Table of Contents
Advertisement
Section 5 - Maintenance
IMPORTANT: Use only the specified coolant.
2.
If the coolant is being replaced or the level is low, slowly add the specified coolant to the level indicated in the table.
Coolant level in expansion tank
QSD 2.0L
Tube Ref No.
Marine Engine Coolant
123
(Only available in Europe)
Fleetguard Compleat with
DCA4, Fleetguard Part
Number CC2825
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
3.
If the boat is out of the water, both the engine and sterndrive must be supplied with cooling water. See the Flushing the
Seawater System section of this manual.
4.
Do not install the pressure cap. Start and operate the engine at fast idle speed between 600 and 1400 RPM. Add coolant
as necessary to maintain the coolant at the level specified previously.
IMPORTANT: When installing the pressure cap, be sure to tighten it securely to avoid coolant loss.
5.
Install the pressure cap after the engine has reached normal operating temperature (with the thermostat fully open) and the
coolant level remains constant.
6.
Test the engine operation. Observe the temperature gauge and check the engine for coolant leaks. If the temperature
gauge indicates the presence of excessive temperature or coolant is leaking, stop the engine immediately and inspect for
the cause.
7.
After the first operation, allow the engine to cool.
8.
Remove the pressure cap and add the specified coolant to the level indicated in the table.
Coolant level in expansion tank
2.0
9.
Install and securely tighten the pressure cap.
Corrosion Protection
General Information
Whenever two or more dissimilar metals (such as those found on this power package) are submerged in a conductive solution
such as saltwater, polluted water, or water with a high mineral content, a chemical reaction takes place causing electrical
current to flow between metals. The electrical current flow causes the metal that is most chemically active, or anodic, to erode.
This erosion is known as
package components exposed to water.
To help control the effects of galvanic corrosion, Mercury power packages come with several sacrificial anodes and other
corrosion protection devices. For a more comprehensive explanation of corrosion and corrosion protection refer to the Marine
Corrosion Protection Guide.
IMPORTANT: Replace sacrificial anodes if eroded 50% or more. Mercury strongly recommends avoiding the use of anodes
from other manufacturers. Refer to your Mercury Diesel authorized repair facility for additional information.
Engine Corrosion Protection Components
The engine is equipped with a sacrificial anode located in the end cover of the engine aftercooler to assist in protecting the
engine and the seawater cooling system from corrosion.
Removal
1.
Allow the engine to cool.
Page 82
Description
Within 25 mm (1 in.) of the top of the filler neck
galvanic corrosion and, if it is not controlled, it will eventually cause the need for replacement of power
Within 25 mm (1 in.) of the top of the filler neck
Where Used
Closed cooling system
Closed cooling system
NOTICE
Part No.
92-813054A2
Obtain Locally
90-8M0069751
APRIL 2012
eng
Advertisement
Table of Contents
