Table Of Contents; Tools Required - Keysight Technologies E6650AU-TRX Installation Note

Introduction
Introduction
The following instructions will guide you through the process of adding and an additional M9440A
TRX module into the E6650A main frame /chassis.

Table of Contents:

- Tools Required
- Remove Face Plate Panel
- Remove New TRX Module Filler Plate from Dress Panel
- Remove Impact Cover
- Remove Module Slot Fillers
- Install the TRX Module and Cable Connections
- Install Impact Cover and Dress Panel
- Enable the New TRX Module (in the XSA configuration file)
- Enable the New TRX Module (by sending a SCPI command)
- Update the FPGA Code
- Back Up New TRX Module Calibration Data to Hard Drive
- Run Self-Test Manual Verify

Tools Required

- T-10 TORX Driver
- T-20 TORX Driver
- #1 Phillip screwdriver
- Needle nose pliers
- Calibration Void if Broken sticker (PN: 7121-5432)
- USB keyboard and mouse
- E6650AU-TRX kit
Optional
- Cable removal tool (PN: 5002-3361)
4 Installation Note E6650-90013