Technical Data - NetterVibration NTP Series Operating Instructions Manual

Technical data

3 Technical data
Permissible Drive
medium
operating
conditions
Lubrication
Ambient
temperature*
Operating
pressure*
sent of application engineers from NetterVibration.
Clocked
operation
NTP B + C may only be operated clocked.
A duty time of max. 60 s must be followed by a pause of at least 60 s. Al-
ternatively, with a short duty time (≤ 12 s) a pause factor of 5 may be used
(e.g.: duty time 5 s - pause time 25 s).
The type designations of the NTP differ as follows:
Type
designation
NTP B
NTP B+A
NTP B+C
NTP B+C is the standard version.
NTP must be operated with clean, lubricated compressed air or lubricated
nitrogen according to the following specification:
ISO 8573-1
Filter ≤ 5 µm
Humidity,
Pressure dew point ≤ +10 °C
Total oil content
≤ 5 mg/m
NTP L versions are suitable for operation with oil-free, dried com-
pressed air according to the following specification:
ISO 8573-1
ISO viscosity class according to DIN ISO 3448, VG 5 to 15
Fill the mist lubricator with acid- and resin-free compressed air oil.
Recommendation for tempera-
tures from 0 to 60 °C:
Klüber "AIRPRESS 15"
Specification for temperatures
from 0 to -20 °C:
Klüber "ISOFLEX PDP 10"
Standard and NTP L versions: 5 °C to 60 °C
NT versions:
-32 °C to 60 °C
2.0 to 6.0 bar
* Higher operating pressures and temperatures are only permitted after consultation with and the written con-
have no impact plate, the piston swings against an air cush-
ion.
have an impact plate made of steel in the base plate (hard-
hitting with high noise level).
have an impact plate (elastomer disc) that is inserted in the
base plate.
3
IMPORTANT
[ 5 6
:
[ 5 6
:
Specification for temperatures above
60 °C with HT designs:
Aral "Farolin"
Specification for temperatures
below -20 °C for NT versions:
®
"BREAK FREE CLP"
HT versions:
5 °C to 160 °C, depending on version
4 ]
:
2 ]
:
7