Table of Contents
Advertisement
P/N 0518279_A
Before beginning installation, carefully
unpack and inspect the Light Bar Kit
making sure there is no breakage or
damage.
Note: Make sure that Light Bar Kits
are installed before placing cases in
lineup.
Caution:
Remove fasteners from
studs and reattach to one bracket
at a time. Failure to do this can cause
damage to the case.
1
Remove Hex Nuts/Washers from
studs on rear of case. Fasten the
Light Bar Mounting Brackets –1
to the rear upright frame assemblies by
sliding the holes over the studs and
fastening using the same nuts and
washers.
2
When attaching brackets make sure
that the brackets are fastened to the
inside of each upright (see illustra-
tions for locations).
1
End View of
8 Ft Merchandiser
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
1
Installing Mounting Brackets to Upright Frame Assembly
Hex Nut and Washer
Location of Mounting Brackets on Upright Frame Assemblies
Remove Hex Nut and
Washer and Reuse
Left Rear of Merchandiser
Rear View of 8 Ft Merchandiser
Location of Mounting Brackets
Rear View of 12 Ft Merchandiser
Self-Contained Merchandisers
Studs
Upright Frame
Assembly
Location of Mounting Brackets
Uprights
1-9
Advertisement
Table of Contents
