Average - Pfeuffer HE lite Operating Instructions Manual

Operating instructions HE lite
7.6

Average

The HE lite is equipped with an average
function, allowing you to calculate
automatically the average of up to six
measurements. This
particularly useful, in case of very different
conditions (close to the forest, bottom of
valleys, etc.) in order determine the
average of the moisture reading to be
expected.
For the setting of the average function
please proceed as follows:
Select the function Average and confirm
by pressing .
Offset
→ Average
Illumination
↑
Two parameters are indicated on the
display:
→ AV f. Meas. 0
at Display
+
© 2017 – Pfeuffer GmbH
function is
Set ↓
0
Set –
»AV f. Meas« means the number of
measurements included in the calculation
(adjustable from 1 to 6; factory setting
»0«, i. e. the average calculation is
switched off).
»at Display« means the number of
measurements of one product which are
indicated simultaneously (adjustable as a
function of »AV f. Meas«). Figure »1«
means just the same indication as it is
during the standard measurement, only
the last reading and the number of values
included in the average calculation are
indicated. Figure »2« to »6« means that all
single readings included in the average
reading are
measurement. In both cases the average
reading is indicated in the line before last
next to the selected product.
The following paragraph describes the
procedure of the average function and
the simultaneous presentation of 3
measurements:
Change the »AV f. Meas« to »3« by
means of the left button
Revision 9
indicated during

→ AV f. Meas. 3
at Display 0
+ Set –
the
.
Page 19 of 28