Surveillance; Nmea; Calibration & Diagnostics Menu; Ir Test Pattern - FLIR M500 Operator's Manual

Settings Menu
Surveillance... See "Surveillance:" on page 22.
NMEA... See "NMEA Settings" on page 30.
Calibration & diagnostics Menu
IR test pattern: (On/Off)
Activate spotlight test: Click to run.
Activate pan and tilt test: Click to run.
Reset IR Lens: Click to run.
Set Az & El zero reference: Icons on the video show the direction the camera is facing in
relation to an outline of a ship. The M500 camera has a "forward" direction adjustment which has
been set at the factory. After the camera is installed, both the azimuth and elevation should be set
to account for variations required during installation so that the icons on the video show the
expected angular position of the camera. The azimuth direction should be directly toward the front
of the vessel; the elevation may be set to the horizon or another user preferred reference.
1. Using the JCU II, point the camera directly ahead and choose an elevation reference point.
For example, place the horizon in the center of the video.
2. Press the Menu button to turn the OSD menu on.
3. Navigate to Set-up Menu, Calibration &
diagnostics..., then select Set Az & El zero
reference.
4. Select Set origin to set the azimuth and elevation
offsets.
5. Verify that the icons on the video correspond to the
direction the camera is pointing.
432-0012-01-10 Version 110 August 2020 26