Assembling The Saw Vices; Vice Operation; Assembling The Lateral Extension Wings - PEUGEOT Energysaw-305DB Operating Instructions Manual

2. TABLE ROTATION AND MITRE STOPS
The table has mitre stops at 0°, 15°, 22.5°, 30° and 45° to the left and right. When you turn the table, it will automatically stop
at the next stop.
To turn the table, make sure that the mitre handle is unlocked and turn the table to the required angle. Then tighten the
mitre handle once more.

3. ASSEMBLING THE SAW VICES

The vertical and horizontal vices may be fitted to the left or
right of the saw and are fully adjustable to the workpiece.
Do not use the saw without first clamping the workpiece.
Position the vertical vice (A) Fig.3 by inserting the rod (B) of
the vice into one of the holes on the guide fence and tighten
the locking knob (C) against the rod of the vice.
Position the horizontal vice by inserting it into one of the
holes located on the base of the saw.
To adjust the vice position, turn the handle or lift the knob
(B) Fig.4 and then push or pull the vice depending on the
size of the workpiece to clamp.
Lock the vice in position by pressing knob (B) against the
threaded rod (A).

4. VICE OPERATION

1. The height of the vertical vice or the width of the horizontal vice may be adjusted by loosening the locking knobs and
sliding the body of the vices up, down, forward or backwards. Once the height or width of the vice has been adjusted, tighten
the locking knobs once more.
2. Position the vertical vice or horizontal vice so that the underside of the pads is slightly in contact with the top of the work-
piece.
3. To finally clamp the workpiece against the table, screw the knobs until the workpiece is clamped. After cutting, loosen the
locking knobs to slide away or remove the workpiece.

5. ASSEMBLING THE LATERAL EXTENSION WINGS

The mitre saw is supplied with two lateral extension wings
(A) Fig.5 to support larger workpieces when they are being
cut. The extension wings may be assembled on either side of
the saw, depending on the size of the workpiece.
Loosen the locking knob (B), insert the extension wings in
the holes located on either side of the saw base and tighten
the locking knob (B) once more.
53
3
4
5