Table of Contents
Advertisement
MACHINE IDENTIFICATION
A.
Operating handle
M.
Guide fence
B.
Laser On/Off switch
N.
Rotating saw table
C.
Trigger switch
0.
Bevel scale
D.
Lower blade guard
P.
Bevel lock lever
F.
Vertical vice
Q.
Sliding mechanism
G.
Table extensions
R.
Grooving stop
H.
Dual-line laser
S.
Dust bag
1.
Kerf plate
T.
Motor
J.
Mitre handle
U.
Upper blade guard
K.
Mitre scale
L.
Horizontal vice
ASSEMBLY
A , IMPORTANT: Make sure that the saw is switched off and disconnected from the power source before any assembly or
—
1
adjustment operations.
1. ASSEMBLING THE MITRE HANDLE
Before using your double bevel sliding compound mitre saw, you must assemble the mitre handle (J) Fig. 2.
Screw the handle on (J).The handle is used to lock the table at the required angle while cutting mitres.
, IMPORTANT! Before starting a cut, make sure that this handle is locked and that the saw table is locked In place.
m
n P E U G E O T
2. TABLE ROTATION AND MITRE STOPS
The table has mitre stops at 0°, 15°, 22.5°, 30° and 45° to the left and right. When you turn the table, it will automatically stop
at the next stop.
To turn the table, make sure that the mitre handle is unlocked and turn the table to the required angle. Then tighten the
mitre handle once more.
3. ASSEMBLING THE SAW VICES
The vertical and horizontal vices may be fitted to the left or
right of the saw and are fully adjustable to the workpiece.
Do not use the saw without first clamping the workpiece.
Position the vertical vice (A) Fig.3 by inserting the rod (B) of
the vice into one of the holes on the guide fence and tighten
the locking knob (C) against the rod of the vice.
1
\
Position the horizontal vice by inserting it into one of the
holes located on the base of the saw.
To adjust the vice position.'turn the handle or lift the knob
(B) Fig.4 and then push or pull the vice depending on the
size of the workpiece to clamp.
Lock the vice in position by pressing knob (B) against the
threaded rod (A).
4. VICE OPERATION
1. The height of the vertical vice or the width of the horizontal vice may be adjusted by loosening the locking knobs and
sliding the body of the vices up, down, forward or backwards. Once the height or width of the vice has been adjusted, tighten
the locking knobs once more.
2. Position the vertical vice or horizontal vice so that the underside of the pads is slightly in contact with the top of the work-
piece.
3. To finally clamp the workpiece against the table, screw the knobs until the workpiece is clamped. After cutting, loosen the
locking knobs to slide away or remove the workpiece.
5. ASSEMBLING THE LATERAL EXTENSION WINGS
The mitre saw is supplied with t w o lateral extension wings
(A) Fig.5 to support larger workpieces when they are being
cut. The extension wings may be assembled on either side of
the saw, depending on the size of the workpiece.
Loosen the locking knob (B), insert the extension wings in
the holes located on either side of the saw base and tighten
the locking knob (B) once more.
T
B
Advertisement
Table of Contents
