Siemens SIRIUS 3RW50 Manual page 144

Functions
7.11 3RW5 HMI Standard
Measured values
Parameter list
144
Display Explanation
LOCL Manual mode
CNTRL
REMT Automatic
CNTRL
Display Explanation
...A The average of the 3 phase currents is displayed in amps.
I AVG
...A Current measured value phase L1 is displayed in amps.
I L1
...A Current measured value phase L2 is displayed in amps.
I L2
...A Current measured value phase L3 is displayed in amps.
I L3
Display Explanation
.. Current limiting value as a multiple of the set rated operational current I
xIe motor.
...% Starting voltage
U ON
...s Ramp up time
t ON
...s Stopping time
t OFF
... Tripping class for motor overload protection
CLASS
...A Rated operational current I
Ie
.... AUTO
RMode
MAN
REMT
... Station address for PROFIBUS (only displayed if a "PROFIBUS" communication
module is being used)
PBADR
... Station address for Modbus (only displayed if a "Modbus RTU" communication
module is being used)
MODBS
CNTRL (CONTROL)
The master control function is with the 3RW5 HMI Standard
("Manual operation local - HMI controlled" mode).
Master control function is not with the 3RW5 HMI Standard.
To make the unit the master control, press the LOCAL /
REMOTE key. Refer to Chapter Operating modes and master
control function (Page 15).
of the motor
e
Auto RESET
Manual RESET
Remote RESET
Manual, 09/2019, A5E35628455002A/RS-AA/001
of the
e
SIRIUS 3RW50 soft starter