Operating Your Air Conditioner; Starting Your Air Conditioner - Whirlpool ACQ152XK0 Use And Care Manual

Operating Your Air Conditioner

EN
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn the air conditioner off, wait at least 3 minutes before turning it back on. This prevents the air conditioner from
blowing a fuse or tripping a circuit breaker.
• Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The
inside evaporator coil will freeze up and the air conditioner will not operate properly.

Starting your air conditioner

Press Power ON/OFF to turn on air
conditioner. When air conditioner is turned on
for the first time after it is plugged in, it will
display the default settings: COOL mode, TURBO fan
speed, 72°F. When it is turned on all other times, it will
display the previous settings.
TEMPERATURE SELECTION
Press to raise the temperature.
Each time you press or hold
the temperature will go up 1° until
it reaches 86°F.
Press to lower the temperature.
Each time you press or hold
the temperature will go down 1° until it reaches 64°F.
MODE SELECTION
Press MODE until you see the indicator light
come on for the setting you want. Choose
AUTO, COOL, FAN or POWER SAVER.
AUTO – Cools room while it automatically
controls fan speed. You cannot change fan
speed, but you can adjust temperature by
pressing or .
COOL – Cools room. You can select fan speed by
pressing FAN SPEED. You can then adjust
temperature by pressing
FAN ONLY – Fan runs on TURBO speed only. Only
the fan runs. Display shows "FO" (fan only).
POWER SAVER – Fan runs only when cooling is
needed. Fan stops running when the room
temperature matches the temperature you set.
Press FAN SPEED until you see the indicator light
for the setting you want. Choose TURBO, HIGH
or LOW.
Select the temperature by pressing
FAN SPEED SELECTION
NOTE: FAN SPEED button will operate only
when COOL or POWER SAVER mode has
been selected.
Press FAN SPEED until you see the indicator
light for the setting you want. Choose
TURBO, HIGH or LOW.
Power
ON/OFF
,
,
AUTO
COOL
FAN
POWER
SAVER
MODE
or .
or .
TURBO
HIGH
LOW
FAN
SPEED
Power
TIMER
ON/OFF
ON/OFF
AUTO
COOL TURBO
FAN HIGH
POWER
LOW
SAVER
FAN
MODE
SPEED
5