Operating Your Air Conditioner - Whirlpool COOL IMPRESSION SERIES Owner's Manual

Operating Your
Air Conditioner
In This Section
Page
Page
Using the AUTO COOL Cycle . . . . . . . . . . . . . . . 6
Using the TIMED OFF
Modifying the temperature
HOURS Cycle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
. . . . . . . . . . . . . . . . . . . . 7
Modifying the fan speed . . . . . . . . . . . . . . . . . . . . . . . . 7
Using the CHECK FILTER light . . . . . . . . . . 10
Turning the unit off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Modifying the air direction . . . . . . . . . . . . . . . . . . . 11
Using the DRY ONLY Cycle . . . . . . . . . . . . . . . . . .
Using the exhaust door . . . . . . . . . . . . . . . . . . . . . . . 11
8
Using the SLEEP HOURS Cycle . . . . . . . . . . 9
Using the remote control . . . . . . . . . . . . . . . . . . . . . 11
Operating your air conditioner properly is
essential to obtain the best possible results.
DO NOT disconnect the air conditioner
This section tells you about each cycle and
from its electrical supply. DO NOT use an
how to operate it.
electrical outlet that can be turned off with
a switch. When the air conditioner is
f
IMPORTANT: After turning the unit off,
disconnected from its electrical supply
wait approximately 3 minutes before
(including power outages) all
turning it back on. If you don't wait app-
programming reverts back to the
roximately 3 minutes, the air conditioner
factory-preset information. However, the
will try to start, but turn itself off until the
air conditioner will "relearn" your
compressor is ready to start again.
preferences.
Using the AUTO COOL Cycle
(Single-Button Cooling)
The AUTO COOL Cycle is designed to
provide you with the comfort you desire by
continually "learning" your preferences.
Once the Cycle "learns" what temperature(s)
you desire, it automatically chooses a fan
speed when turned on and cools the room
as quickly as possible.
NOTE: You can modify the fan speed and
temperature when using the AUTO COOL
Cycle, if desired. See "Modifying the fan
speed" or "Modifying the temperature" on
page 7.
To activate the AUTO COOL Cycle:
l
Press the AUTO COOL/ON Button.
NOTE: When the cycle is active, the
indicator light on the AUTO COOL/ON
Button will be lit.
6
AUTO COOL BURST
AUTO COOL BURST cools the room for
15 minutes before allowing the room to rise
to your prelearned temperature. This cycle
is especially useful if you are hot from
exercise or it is very hot in the room.
To activate AUTO COOL BURST:
l
Press the AUTO COOL/ON Button twice.
\I/
-m-
/I\
AUTO COOL
0
ON