Planet Networking & Communication IGS-5225 Series User Manual page 210

The page includes the following fields:
Object
•
Delete
•
VLAN ID
• IGMP Snooping Enable
• Querier Election
• Querier Address
• Compatibility
• PRI
• RV
Figure 4-3-5-8: IGMP Snooping VLAN Configuration Page Screenshot
Description
Check to delete the entry. The designated entry will be deleted during the next
save.
The VLAN ID of the entry.
Enable the per-VLAN IGMP Snooping. Only up to 32 VLANs can be selected.
Enable the IGMP Querier election in the VLAN. Disable to act as an IGMP
Non-Querier.
Define the IPv4 address as source address used in IP header for IGMP Querier
election.
■
When the Querier address is not set, system uses IPv4 management
address of the IP interface associated with this VLAN.
■
When the IPv4 management address is not set, system uses the first
available IPv4 management address. Otherwise, system uses a
pre-defined value.
By default, this value will be 192.0.2.1
Compatibility is maintained by hosts and routers taking appropriate actions
depending on the versions of IGMP operating on hosts and routers within a
network. The allowed selection is IGMP-Auto, Forced IGMPv1, Forced
IGMPv2, Forced IGMPv3.
Default compatibility value is IGMP-Auto.
(PRI) Priority of Interface. It indicates the IGMP control frame priority level
generated by the system. These values can be used to prioritize different classes
of traffic.
The allowed range is 0 (best effort) to 7 (highest), default interface priority value
is 0
Robustness Variable. The Robustness Variable allows tuning for the expected
User's Manual of IGS-5225 series
210