Installing Side Curtains; Positioning Air Conditioner In Window - Whirlpool ACQ058MM0 Use And Care Manual

Installing side curtains

WARNING
Excessive Weight Hazard
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other
injury.
Attach curtains to unit before placing unit in window.
1. Remove unit from packaging.
2. Locate supplied bag of 6 screws.
3. Insert top and then bottom of right curtain housing (A) in
top and bottom curtain guides (B) on air conditioner.
4. Extend right curtain outward so you may insert the first
screw (C) through the middle hole of the curtain. Screw
curtain to middle hole in air conditioner cabinet. This screw
is required to correctly attach curtain (top to bottom) to the
air conditioner cabinet.
5. While the right curtain is still extended, insert another screw
(C) in top slot of curtain. Screw curtain to top hole in air
conditioner cabinet.
6. While the right curtain is still extended, insert another screw
(C) in bottom slot of curtain. Screw curtain to bottom hole in
air conditioner cabinet.
7. Slide curtain housing into guides as far as it will go.
8. Repeat above steps for left curtain, then go to "Positioning
the air conditioner" below.

Positioning air conditioner in window

WARNING
Excessive Weight Hazard
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other
injury.
1. Using two people, lift air conditioner into place.
NOTES:
• Handle air conditioner with care.
• Air conditioner should be placed no more than 4 ft (122
cm) from a grounded outlet.
2. Center air conditioner in window. Check that lower rail of
air conditioner is behind and against back side of window
seal. Lower window sash (A) to hold cabinet in place.
NOTES:
• Do not block the louvers in the front panel.
• Do not block the openings on the outside of the air
conditioner.
3. Check that air conditioner cabinet is tilted to the outside so
that water will run to the outside. There should be a tilt to
the outside of about 1/2 bubble (B). If cabinet is not
properly positioned, reposition or shim cabinet to provide
the proper tilt.
6
A
B
back view
C
1/2 bubble tilt
A
B
bottom view
A
B