Installing The Cabinet In A Window - Whirlpool ACE184XS0 Use & Care Manual

1. Remove airconditioner from carton andplace it on
cardboard.
2. Remove shipping screws f rom each side wall o fcabinet.
A. Shipping screws
3. Remove front panel from air conditioner and set aside.
4. Remove ground screw and ground wire from front of air
conditioner base. Save ground screw.
5.
_) .......B
A. Green ground wire
B. Ground screw
Pull on handle to slide air conditioner out of cabinet. Place air
conditioner on cardboard.
A. Handle
NOTE: Do not lift, push, pull or remove any expanded
polystyrene (foam) from inside the air conditioner. It is not
packing material.
Shipping bracket removal (on some models)
1. To remove upper shipping bracket from unit support bracket,
cut the 2 wire ties with scissors.
2. Lift the end of the upper shipping bracket off of the unit
support bracket and remove the other end from compressor
flange.
A
B
C
A. Wire ties (2)
B. Unit support bracket
C. Upper shipping bracket
F
D. Compressor flange
E. Remove this screw
F. Lower shipping bracket
3. Remove screw from end of lower shipping bracket attached
to divider wall using a 1/4"nut driver or socket wrench.
4. Remove the other end of lower shipping bracket from
compressor flange.
NOTES:
• If compressor flange interferes with sliding air conditioner
back into cabinet, bend flange back against the compressor.
• Reinstall shipping brackets only if unit will be moved from its
present location.
• Handle air conditioner gently.
• Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
• The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the air conditioner.
Filler board installation
1. Center empty cabinet in window. Maintain a firm hold on the
air conditioner cabinet. Lower window sash to hold cabinet in
place.
2. Measure the distance between the right side of the cabinet
and the inside of the window channel.
3. Repeat for the left side.