Table of Contents
Advertisement
PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
CAUTION: Always make sure the trigger safety lock is in the 'locked' position when not in use or connecting/
disconnecting the pressure hose. Always check water hose, pressure hose, lance and nozzle are not damaged,
broken or worn before use.
CAUTION: The pressure washer/compressor is equipped with a thermal cut-out. If for any reason the pressure
washer/compressor does overheat the device will automatically turn the unit off. If this happens switch the pressure
washer/compressor off and unplug from the mains. Remove the lance, nozzle and filter and check for blockages.
Allow the pressure washer/compressor to cool down for approximately 4 hours.
Preparing your pressure washer/compressor
Line up and slide the handle into
the slots on the top of the pressure
washer/compressor.
A trigger safety lock is located
underneath the handle. The safety lock
should always be in LOCKED position
before connecting/disconnecting the
pressure hose to the trigger handle.
Insert both screws into the handle screw
holes. Using a crosshead screw driver
tighten screws.
Press the pressure hose release button
located on the side of the trigger han-
dle. Holding the button down, push the
pressure hose into the hose connection
on the trigger handle, underneath the
hose release button.
Getting started
Push the pressure hose connector firmly
into the water outlet and turn the pressure
hose collar clockwise until tight.
Release the button, continue to firmly
push the pressure hose into the hose
connection on the trigger handle. The
hose release button will pop out when the
pressure hose is correctly fitted. Gently
pull the pressure hose to make sure it is
securely locked.
Advertisement
Table of Contents
