Getting Started - Vax VPW2S PowerPlus STEAM User Manual

PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
CAUTION: Always make sure the trigger safety lock is in the 'locked' position when not in use or
connecting/disconnecting the pressure hose. Always check water hose, pressure hose, lance and nozzle
are not damaged, broken or worn before use.
CAUTION: The pressure washer/steamer is equipped with a thermal cut-out. If for any reason the pressure
washer/steamer does overheat the device will automatically turn the unit off. If this happens switch the
pressure washer/steamer off and unplug from the mains. Remove the lance, nozzle and filter and check for
blockages. Allow the pressure washer/steamer to cool down for approximately 4 hours.
Preparing your pressure washer/steamer
Push the pressure hose connector
firmly into the water outlet and turn
the pressure hose collar clockwise
until tight.
Press the pressure hose release button
located on the side of the trigger
handle. Holding the button down,
push the pressure hose into the hose
connection underneath the button.
A trigger safety lock is located underneath
the handle. The safety lock should always
be in LOCKED position before connecting/
disconnecting the pressure hose to the
trigger handle.
Release the button, continue to firmly push
the pressure hose into the trigger handle.
The release button will pop out when the
pressure hose is correctly fitted. Gently
pull the pressure hose to make sure it is
securely locked.

Getting started