Table of Contents
Advertisement
Getting started
PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
Always make sure the pressure washer and water supply is off before connecting or disconnecting the hose
and accessories.
Assembling your pressure washer
Attach both wheels
Attach the hose connector
and push until they
to water inlet by turning
click into place.
clockwise until tight.
IMPORTANT: Always make sure the trigger safety lock is in the LOCKED position when not in use or connecting
/disconnecting the pressure hose.
Always check water hose, pressure hose, lance and accessories are not damaged broken or worn before use.
Preparing your pressure washer for use
Push the pressure hose firmly
A trigger safety lock is located
to the water outlet and turn the
underneath the handle. The safety
pressure hose collar clockwise
lock should always be in LOCKED
until tight.
position before connecting/
disconnecting the pressure hose to
the trigger handle.
Whilst firmly pushing the lance
To remove the lance from the trigger handle
into the trigger handle turn
firmly push and twist the lance anti-clockwise.
clockwise to lock into position.
When unlocked pull to remove.
Slot the handle in to the
Align the pressure hose and
top of the machine and
cord storage hook onto the
insert the 2 screws, turn
back of the machine and
clockwise to tighten.
secure with 2 screws.
UNLOCKED
LOCKED
To connect pressure hose to trigger
handle, press the pressure hose
release button and push pressure
hose to lock into position. Gently
pull the pressure hose to check the
connection.
After connecting
pressure hose, lance
and accessories check
they are securely fitted
and lock in place before
turning on.
IMPORTANT: Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
WARNING: Don't leave the pressure washer running when not in use, or more than 5 minutes to prevent overheating.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks in the
machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
Make sure water supply
Connect water hose pipe to
is not connected. Firmly
a suitable water supply and
push the water hose pipe
turn water on.
with suitable connector
onto the water inlet to
lock into position.
Push the 'I' switch to turn on.
Squeeze the trigger on the trigger
The machine will run for a
handle to release a high pressured
few seconds then stop but no
water jet, and start cleaning.
water will be released.
Push 'O' switch to turn off.
Using your machine
Before plugging the machine
Connect the power cord
in, press the unlock safety
to the mains supply via
button on the trigger handle
an RCD adaptor.
and squeeze the trigger until
water starts to flow through
the nozzle.
Advertisement
Table of Contents
