Vax PowerPlus VPW2C Manual page 12

Using your machine
IMPORTANT: The lance and accessory nozzle must be attached to the trigger handle for pressurised
water to be produced.
CAUTION: Always make sure the pressure washer/compressor is switched off and the safety button on the
trigger handle is in the locked position before connecting/disconnecting the lance, nozzles or accessories.
Using your accessories
Firmly push the chosen accessory
nozzle into the lance until it clicks and
locks into place. Gently pull the nozzle
to make sure it is locked and secure
before use.
Using solution with your pressure washer
Unhook the solution tube and insert
into solution bag. Always make sure
the solution tube is fully submerged
into the solution/water mix inside the
solution bag.
IMPORTANT: When using solution only use Vax solution and make sure you follow the dilution instructions.
Solution can only be dispensed when low pressure accessories such as the solution nozzle, (brush and rotary brush
is attached – (supplied with certain models only). Solution cannot be used with jet or turbo nozzles.
Jet nozzle (Orange nib)
The jet nozzle has a wider spray and
is ideal on surfaces such as cars,
garden furniture, decking and boats.
Attach the solution nozzle
(white/black nib) to lance, making
sure it is locked and secure
before use.
Turbo nozzle
The turbo nozzle has a more
concentrated spray and is ideal for
use on very dirty surfaces, patios or
masonry. It is fitted with a pressure
regulator and is not suitable for use
on delicate or painted surfaces.
After using solution, rinse fresh water
through your pressure washer to prevent
blockages. Insert the solution tube into a
bucket of fresh water (Max 40˚C) turn
the pressure washer on and squeeze the
trigger for 1 minute.