Plastic Grille Installation - Whirlpool 1188177 Use And Care Manual

1. Measure the existing wall sleeve.
2. See the section that matches the dimensions of the existing
wall sleeve.
E
D
A. Width (W) D. Horizontal insulation strip
B. Height (H)
C. Depth (D)
Wall sleeve dimensions (W x H x D):
25 " x 15 " x 17 " (64.8 cm x 38.7 cm x 44.5 cm),
25 " x 16 " x 18 " (65.4 cm x 42.9 cm x 47.3 cm),
25 " x 16 " x 17 " (65.7 cm x 41.9 cm x 44.5 cm) or
26" x 15 " x 16 " (66 cm x 39.7 cm x 42.9 cm)
1. Remove the existing grille from the wall sleeve.
2. Remove all debris from inside the wall sleeve.
3. Insert new grille into wall sleeve.
NOTE: Make sure that the word "Top" is readable from inside
the room.
4. Using the grille as a template, mark locations of 2 holes on
each side of the wall sleeve. Drill
sleeve.
A
A. Drill " holes into the wall sleeve.
6
A
C
E. Vertical insulation strip
" holes into the wall
5. Attach the rear grille using #8 - 32 sheet metal screws
(provided).
B
Insert the 4 - #8 - 32 sheet metal screws (provided)
through the holes in the grille and into the wall sleeve.
Wall sleeve dimensions:
26 " x 15 " x 15" (68 cm x 40 cm x 38.1 cm),
27" x 16 " x 16 " (68.6 cm x 42.6 cm x 42.6 cm), or
27" x 16 " x 19 " (68.6 cm x 42.6 cm x 50.2 cm)
These sleeves require a larger rear grille and installation parts
than the ones provided with this air conditioner. See your local
supplier for a kit to fit this size wall sleeve.
NOTE: If you install your new air condtioner into this size wall
sleeve without using the kit, you will cause damage to your new
air conditioner and the warranty will be void.
1. Cut the plastic grille 26 " (67.3 cm) wide and 15 " (39.4 cm)
high.
2. Place the plastic grille inside the wall sleeve at the rear flange.
A

Plastic Grille Installation