Basic Items To Check For Hardware; Checking Error/Status Codes In The Standard Iec 62591 Application - Emerson IEC 62591 Instruction Manual

4.2.2 Basic Items to Check for Hardware

4.2.3 Checking Error/Status Codes in the Standard IEC 62591
Application
Revised October-2019
IEC 62591 Wireless Interface Instruction Manual (for ControlWave Micro)
Figure 4-1. Wireless Interface
▪ Ensure power is connected.
▪ Check that all modules are properly seated in slots.
▪ Ensure cable connections are good between the field link and
controller, and between the PC/laptop and the controller.
▪ Check status LEDs on the controller. For information on what the
LEDs mean, see the ControlWave Micro instruction manual (part
D301392X012).
▪ Check for indications on the Smart Wireless Field Link. See its
accompanying documentation for details.
This procedure assumes that:
Note:
▪ You have ControlWave Designer installed on the PC/laptop.
▪ You are running the standard IEC 62591 application
(ControlWave project) in the ControlWave Micro and have
an identical copy of the project on the PC/laptop.
▪
You have a successful communication connection between
the PC/laptop and the ControlWave Micro.
Troubleshooting 4-3