Ballard Designs Biaggi Bar Cabinet Quick Start Manual

PRODUCT NAME: Biaggi Bar Cabinet

ITEM NUMBER: SR021

ASSEMBLED DIMENSIONS : 59 1/4"H x 42"W x 22"D

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

UPDATED: 6-1-2021

Prevent accidentally discarding small parts or

hardware. Retain all carton contents until assembly

and installation are complete.

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

MADE IN ITALY

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the Biaggi Bar Cabinet and is the answer not in the manual?

Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Biaggi Bar Cabinet ITEM NUMBER: SR021 ASSEMBLED DIMENSIONS : 59 1/4”H x 42”W x 22”D Prevent accidentally discarding small parts or hardware. Retain all carton contents until assembly and installation are complete. PRODUCTS ARE NOT INTENDED MADE IN ITALY FOR COMMERCIAL USE.
Page 2 Assemble in location for intended use. Ltr. Qty. Hardware Included REQUIRED TOOLS: Phillips Screwdriver Screws -Two person assembly suggested. Remove all parts, hardware and Connector Pegs protective packaging from carton and carefully arrange on a clean, level, padded surface. Shelf Supports Door Key WARNING Tip-Over Hazard...
Page 3 Assemble in location for intended use. STEP 1: Lower Shelf (G) is installed one side (left/right) at a time. 1. Carefully place Cabinet (F) back down onto a level, padded surface. 2. Insert and tighten a Connector Peg (B) into hole in lower portion of each LEFT leg .
Page 4 WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.

Sr021