Panasonic SC-EN38P Service Manual page 46

SC-EN38P / SC-EN38PC
11.3. Checking & Repairing Tact
Switch P.C.B
Step 1 : Remove Rear Panel.
Step 2 : Remove Transformer P.C.B..
Step 3 : Connect 3P cable at the connector (CN601) on Main
P.C.B..
Step 4 : Tact Switch P.C.B. can be checked at its original
position.
11.4. Checking & Repairing Sensor
P.C.B
Step 1 : Remove Rear Panel.
Step 2 : Remove Transformer P.C.B..
Step 3 : Remove Tact Switch P.C.B. & Sensor P.C.B..
Step 4 : Connect 3P cable at the connector (CN601) on Main
P.C.B..
Step 5 : Connect 8P FFC cable at the connector (CN952) on
Main P.C.B..
Step 6 : Check & repair Sensor P.C.B. according to the
diagram shown.
46