Permobil R-net (PJSM)
2.5.2.2
Pairing setup
The control panel Bluetooth® must then be put into Discovery
Mode by following this sequence description:
• Deflect the joystick in the forward direction and hold until there
is a beep. This takes approximately 10 seconds; then release.
• Deflect the joystick in the reverse direction and hold until there is
a beep. This takes approximately 10 seconds; then release.
The screen will display a flashing Bluetooth® icon above the
computer image. This confirms that the control panel Bluetooth® is
set in Discovery Mode. It is now discoverable for other Bluetooth®
devices.
2.5.2.3
Pairing with different devices
Depending on the type of device you are pairing with; a PC, an
Android™ device or an iDevice®, you will need to follow a specific
procedure depending on the device you want to connect to.
Some procedures are described below.
Permobil Joystick Module for R-net
Figure 28. The arrow points to the flashing Bluetooth®
icon.
31