Table of Contents
Advertisement
Hot Materials - Welded materials are hot and can cause severe burns if handled improperly.
Do not touch welded materials with bare hands.
Do not touch the torch nozzle after welding until it has had time to cool down.
1. Turn OFF the engine when not using the equipment.
2. Inspect all cords and power cables. Replace any cords or power cables that are damaged or
cracked.
3. Disconnect and organize welding cables so they are protected while not in use.
ELECTRIC SHOCK CAN KILL!
Touching live electrical parts can cause fatal shocks or severe burns. Do not touch live electrical
parts.
Wear dry, hole-free insulating gloves and body protection.
Proper Care, Maintenance, and Repair
Always have the power disconnected when working on internal components.
Do not touch or handle the PC board without being properly grounded with a wrist strap. Put the
PC board in a static proof bag to move or ship.
Do not put hands or fingers near moving parts such as the fan.
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep all cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to
control. Keep handles dry, clean, and free from oil and grease. Also refer to the engine manufacturer's
instruction manual for additional information about engine maintenance. The following chart is based
on a normal operation schedule.
Maintenance Interval
Before Each Use
After Each Use
⚠CAUTION
Maintenance
⚠WARNING
⚠CAUTION
Maintenance Point
Inspect all cords and power cables. Replace any cords or power cables
that are damaged or cracked.
Page 21 of 27
Advertisement
Table of Contents
