Klutch 62499 Owner's Manual page 13

b. Note the mounting holes on the axle flange and match it up with the mounting holes
in the main unit frame. The axle gets mounted on the end of the welder controls. Use
the supplied bolts, washers, lock washers, and nuts to secure axle bracket to the
welder frame.
2. Install the wheels.
a. Slide the wheel onto the axle.
b. Slide the large supplied washer onto axle.
c. Hold the wheel and washer on the axle by installing the large cotter pin into the hole
at the end of the axle.
d. Repeat for the other wheel.
3. Install the handles.
a. Identify which handle goes on each side.
b. Use supplied hardware to fasten the large flange with 4 mounting holes to the side of
the frame.
c. Use the supplied hardware to mount the tube leg to the bottom of the welder frame.
d. Repeat for each side.
Weld Cable Connections
Be aware that the ELECTRODE HOLDER will be electrically HOT when the welder is running.
Most DC Stick Welding is performed using DC Electrode Positive (DCEP) welding current. This
means that the electrode holder and welding cable is connected to the Positive (+) Weld Output
Terminal. The Ground Cable and Clamp is then connected to the Negative (-) Weld Output Terminal.
The connectors are twist-lock style connectors. Completely insert the connector into the proper weld
output receptacle and then turn the connector clockwise until it's snug and tight.
⚠CAUTION
Page 13 of 27