Klutch 62499 Owner's Manual page 8

glasses while welding.

Wear proper gloves and protective clothing to prevent your skin from being exposed to hot metals,
UV, and IR rays.

Do not overuse or overheat your welder. Allow proper cooling time between duty cycles.

Keep hands and fingers away from moving parts.

Do not point the torch at a body part of yours or anyone else's.

Always use this welder in the rated duty cycle to prevent excessive heat and failure.
Electrical Shock
Electric arc welders can produce a shock that can cause injury or death. Touching electrically live
parts can cause fatal shocks and severe burns. While welding, all metal components connected to the
electrode are electrically hot. Poor ground connections are a hazard, so secure the ground lead before
welding.

Wear dry protective apparel: coat, shirt, gloves and insulated footwear.

Insulate yourself from the work piece. Avoid contacting the work piece or ground.

Do not attempt to repair or maintain the welder while the power is on.

Inspect all cables and cords for any exposed wire and replace immediately if found.

Use only recommended replacement cables and cords.

Always attach the ground clamp to the work piece or work table as close to the weld area as
possible.

Do not touch the electrode and the ground or grounded work piece at the same time.

Do not use a welder to thaw frozen pipes.
Battery explosion may cause blindness even death!

Always power down this unit prior to any repair work.

Keep battery away from open flames.

Wear a protective mask and rubber gloves when working with the battery.
Engine exhaust is hazardous to your health!

Work only in a well-ventilated area or use a ventilation device to remove exhaust fumes from the
environment where you will be working.

Exhaust gas may cause serious nausea, dizziness and even death.
⚠WARNING
⚠WARNING
⚠WARNING
Page 8 of 27