Table of Contents
Advertisement
8695 4496 / B
F - MAINTENANCE
1 - SERVICING
So that the machine continues to provide good service for as long as possible, a certain minimum of care and
maintenance is necessary
The frequency of this maintenance work is given on the basis of the production of one work station per day.
Maintenance should be more frequent if production is greater.
For the maintenance of the Flexcut 125 CE power source, please refer to instructions IM10375.
For the maintenance of the tool holder PO150D, please refer to instructions 8695 4566.
Your maintenance department may photocopy these pages so that it can follow up maintenance dates and
Date of maintenance :
- Check that the gas circuit operates properly: pressure gauge, pressure regulator, electrovalve,
valve, couplings, etc.
Note : any piping showing the slightest signs of fatigue, wear, damage, should be replaced by a
standard identical pipe.
- Check the condition of all the electrical cables, especially near the torches and in the cable
support chain (change them if required). Check that electrical wires are tightened.
FLEXCUT 125 CE INSTALLATION
operations (tick as appropriate)
Monthly
/
/
F-27
Advertisement
Table of Contents
