Table of Contents
Advertisement
D - ASSEMBLY AND INSTALLATION
6 - TORCH LEAD-BUNDLES INSTALLATION
Refer to document IM10375
7 - POWER SOURCE INSTALLATION
Place the power source near the chain end (see layout).
Connect the power source to a power supply and to a gas or air supply (see the power source's instructions in the
present folder).
Connect the power source to the machine:
-
Connect P1-W60 to the back of the power source
-
Connect the torch harness to the front of the power source
-
Connect the earth cable to the sheet metal holding table
D-22
Important: after connection, check there is no leak
(water and gas) and that no pipe is bent
FLEXCUT 125 CE INSTALLATION
8695 4496 / B
Advertisement
Table of Contents
