Table of Contents
Advertisement
8695 4496 / B
D - ASSEMBLY AND INSTALLATION
1 - CONDITIONS OF INSTALLATION
THE FOLLOWING CONDITIONS MUST BE COMPLIED
1.1
GAS SUPPLY
Provide the gas sources (cylinders, cylinder frames, evaporators etc.) below, each with a regulator that is
capable of supplying the recommended flow rates and pressure values and a shut-off valve if the supply
is through a pipe.
FLEXCUT 125 CE INSTALLATION
WITH BEFORE INSTALLING THE EQUIPMENT
THE LAYOUT OF THE INSTALLATION MUST COMPLY WITH
SAFETY STANDARD NF EN 547 -1 -3 TO ASSURE PERSONAL
PROTECTION.
Never exceed the pressure value of 8 bars.
Starting up the gas sources
Please refer to section :
"6-2 CYLINDER CHANGE PROCEDURE"
in the safety booklet 8695 7050
D-13
Advertisement
Table of Contents
