Adding A Lubricator (Accessory) - Graco 24E025 Instructions-Parts List Manual

Adding a Lubricator (Accessory)

To add an accessory air line lubricator to the kit, you
must order Part No. 244841 Lubricator Accessory Kit.
1. Remove filter/regulator from mount bracket.
2. Remove the pin (B) from the outlet of the filter/regu-
lator.
3. Remove regulator cover.
4. Slide the threaded end insert off (13)with outlet fit-
tings still attached.
5. Install the modular connector (2a) (with o-rings and
grease provided) between the filter/regulator and
the lubricator (L).
6. Install the threaded end insert (13) onto the outlet of
the lubricator (L) with o-ring and grease.
7. Install the three retaining pins (B).
NOTE: On some configurations install the 3/4" npt
fxf elbow with the 3/4" npt fxm elbow supplied with
kit 244841, refer to instructions (form 406512)
included with kit.
3A0293H
1
2a
The lubricator meters oil into the moving air stream to
automatically lubricate air-operated motors. A manual
adjustment in the housing (F), Fig. 2, sets the oil drip
rate into the air stream, which can be monitored through
a sight glass. One to two drops of oil per minute is com-
mon. Use an oil rated at 50 to 200 SUS (ISO grade 7 to
46) at 100°F (38°C), such as Graco motor oil, Part No.
202659.
Refill Lubricator
1. Unscrew the fill plug (Land pour in the oil. The lubri-
cator's capacity is 7 oz. (0.2 liter).
2. Check the oil level with the side sight glass. The
lubricator can be refilled with the system pressur-
ized. However, always relieve the system pres-
sure before removing the bowl for any reason.
Installation
B
B
13
4
r_24e025_3A0293_4a
3