Cleaning - Profi Cook PC-FR 1088 User Manual

temperature to 140°C by further pressing
again.
During temperature setting, the temperature dig-
its are flashing.
Start operation
Press the START/OFF button on the display.
The remaining time and the symbol
played and the numbers have stopped flashing.
• If the device is on standby, no temperature is
selected, and the time stamp shows '00 min'.
Press START/OFF and this value remains
at zero and the unit will remain in standby
mode.
• If you have set the time and temperature
or selected a program, press START/OFF
to start the operation. If an error occurs an
alarm sounds and the device will automati-
cally shut down.
• If here is no error, the heating element heats
up normally until the set temperature and
time are reached. The symbols and numerals
on the display are shown in turn one after
another. Example:
the following:
• When the set temperature is reached
5 beeps can be heard. The display shows the
remaining frying time and controls the status
of the heating element.
During operation, temperature and time cannot
be changed. By pressing
current temperature setting. The display shows
the temperature for 2 seconds and then auto-
matically returns to the remaining frying time. To
change temperature and time, first the START/
OFF button must be pressed to stop the opera-
tion. Then, a change can be made.
are dis-
. The display shows
you can check the
Stop operation
• If the remaining time is '00 min', you hear
5 beeps, and the heating element does not
heat up further. The display shows:
• If a speed-dial button is pressed, the display
will show the food symbol of the program,
and '00' flashes.
• If only temperature or time has been set, '00'
blinks.
- If you press START/OFF during operation,
the operation stops, you will hear 5 beeps
and the heating element does not heat up
further. The display shows
When the remaining time has elapsed, the unit
will stop operating and the display will blink for
3 minutes with '00 min'. If you press a button
within the 3 minutes, the time can be changed
based on the selected temperature. If no key is
pressed within 3 minutes, the display shows the
standby mode. You will hear 1 long beep, and the
temperature setting will be cancelled.

Cleaning

WARNING:
• Always pull the plug out of the mains before
cleaning and wait until the appliance has
cooled down.
• Never submerge the control element in wa-
ter for cleaning. This could result in electric
shock or fire.
CAUTION:
• Never use a wire brush or any other abra-
sive objects.
• Never use harsh or abrasive detergents.
.
61