Check Of The Radiator Heat-Exchanger Surface; Rubber Hoses Check - Kohler KDI 1903M Owner's Manual

5.6 Check of the radiator heat-exchanger surface

NOTE: Component not necessarily supplied by
KOHLER.
• Wear safety goggles when using compressed air.
• The radiator heat-exchange surface must be cleaned on
1. Check the radiator heat-exchange surface A.
2. Clean the surface with a brush soaked in special detergent
if it is clogged.

5.7 Rubber hoses check

The check is carried out by exerting a slight deflection or
bending along the pipe and near the hose clamps.
Components must be replaced if they have clear signs of
cracks, tears, cuts, leaks and do not retain a certain degree
of elasticity.
• If hoses are damaged contact an authorized KOHLER
1. Loosen the four capscrews E. Remove guard F.
2. Check that the:
- Fuel system hoses A are intact.
- Hoses for the cooling circuit B1 and B2.
To access the control of the cooling hoses B1 unscrew the
four screws E and remove the safe guard F.
- Vent system pipes C.
- Air system ducts D.
When the control is finished the safe guard F mount and
tighten the four screws E.
ED0053029510 _14.1
Index
INFORMATION ABOUT MAINTENANCE
For safety precautions see
•
Important
both sides.
Important
workshop.
Danger
Cap. 3.
A
5.6
E
F
B1
D
A
5.7
F
5
B2
C
A
EN
25