Note
Before you store the position, zoom, etc. of the
camera, make sure to install and secure the
camera in place to use it properly.
Recalling the stored status
Press any of the POSITION 1 to 6 buttons in which
you have stored the settings.
Clearing the preset memory
Hold down the RESET button and press the
desired POSITION button 1 to 6 for which you
want to clear the settings.
While holding
down
Notes
• If you want to retain the previous pan and tilt
positions when the power is turned off and
turned on again, store those positions in
PRESET 1.
• Storing or clearing the settings in PRESET 1
takes about 2 seconds longer than for other
preset operations.
• When you are storing or clearing the settings in
one PRESET, you cannot restore, store or clear
the settings in another PRESET.
• For details on the items that can be cleared
from the memory, see "Preset Items"
(page 64).
• You can register or delete the preset even while
the menu is being displayed. However, you
cannot perform the pan/tilt operation.
Operating Menus
This section explains how to configure the
camera using the supplied remote commander.
For details on the menu items, refer to page 27
through page 35.
Displaying a menu
Press the button
you want to clear.
1
2
3
4
5
[IR RECEIVE] cannot be set to [OFF] in the SYSTEM
menu when you operate the menu with the
supplied remote commander. Set [IR RECEIVE] to
[OFF] either using the remote controller or from
the Administrator menu on the web browser.
Returning to the main menu
Press the DATA SCREEN button.
Canceling a menu
When the main menu is displayed, press the
DATA SCREEN button once. When a setting menu
is displayed, press the DATA SCREEN button
twice.
25
Press the DATA SCREEN button.
The main menu is displayed.
Use the or button to move the cursor to
the menu item you want to change.
Press the HOME button.
The selected menu is displayed.
Use the or button to move the cursor to
the setting item you want to change.
Use the or button to change the set
value.
Note